Table of Contents
Advertisement
22
www.aeg.com
14. INSTALLATION
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
820-880 mm
Install the appliance under a kitchen
counter.
Put the appliance adjacent to a water tap
and a water drain.
For the venting of the appliance only
water hoses and mains cable openings
are necessary.
14.1 Adhesive steam
protection
Fit the steam protection on the front part
of the kitchen counter along the entire
width.
The hose should not be
extended by more than
2 metres or water pump-
out problems may occur
Secure dishwasher with
brackets and screws provided
DISHWASHER
Gap on both sides should be
equal, & no greater than
5 mm per side.
kickplate fixing screws
•
If floor is not level, adjust
levelling legs to suit
600 mm
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
SINK
600 mm max
300 mm min
POWER OUTLET
•
600 mm
14.2 Adjusting the height of
the appliance
1. Remove the adjustable plinth.
Advertisement
Table of Contents
