Table of Contents
Advertisement
Programme
P4
P5
P7
P8
P9
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the
quantity of dishes can change the values.
5.2 Information for test
institutes
For all the necessary information for test
performance, send an email to:
6. SETTINGS
6.1 Programme selection
mode and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The activation or the deactivation of
the acoustic signal for end of
programme.
• The selection of the colour for
TimeBeam.
• The activation or deactivation of the
rinse aid dispenser.
• The level of rinse aid according to the
required dosage.
These settings will be saved until you
change them again.
Water
1)
(l)
13.5 - 14.5
13 - 13.5
9.0
4.0
9.0 - 10.5
Energy
(kWh)
1.4 - 1.6
0.7 - 0.9
0.8
0.1
1.0 - 1.2
info.test@dishwasher-production.com
Write down the product number (PNC)
that is on the rating plate.
How to set the programme
selection mode
The appliance is in programme selection
mode when the display shows the
programme number P1.
When you activate the appliance, usually
it is in programme selection mode.
However, if this does not happen, you
can set the programme selection mode
in the following way:
Press and hold simultaneously
until the appliance is in programme
selection mode.
6.2 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
ENGLISH
9
Duration
(min)
150 - 164
60 - 70
30
14
210 - 220
and
Advertisement
Table of Contents
