Mitsubishi Electric MR-WX627Z Operating Instructions Manual page 7

3
Adjustment and Anchoring
Turn the adjustable supports to the
fl oor and anchor them so that the
refrigerator will not move.
Bottom front of refrigerator
Adjust the tilt with the adjustable supports.
Adjust the adjustable supports as shown in the fi gures below to make the refrigerator level.
The right
door tilts
down
Right
Rotate and lower the right side.
* A few days after installation, the fl oor may sink due to the refrigerator's weight. Readjust
the tilt with the adjustable supports.
If the door is still tilted after
adjustment of the supports
When installing the refrigerator
in the corner of a room, one
of the rear supports may sink,
causing the refrigerator to tilt. If
this happens, use a strong board
for adjustment. (Normally, use
a board with a thickness of 2 to
3 mm.)
After adjustment, attach the adjustable support cover.
(The adjustable support cover is stored inside the refrigerator compartment at
shipment)
(To prevent vibration, noise,
movement, and doors left ajar)
Turn the adjustable
supports in the arrow
direction until they touch
the fl oor.
Adjustable support Adjustable support
Anchor the refrigerator to a
strong and level fl oor by adjusting
the adjustable supports.
Otherwise, the refrigerator may
Follow the
move and cause injury.
instructions
The left
door tilts
down
Left
Rotate and lower the left side.
Fully insert the adjustable support cover
horizontally until it touches the rear side.
Adjustable Adjustable
Adjustable e e
support support
support support
cover cover
cover cover
Adjustable e e
support support
Caster Caster
If the refrigerator
tilts forward, the
doors will easily
become ajar.
Rear support Rear support
Strong board Strong board
Beginning Use
The refrigerator takes time
to cool completely.
• Wait until the refrigerator
has suffi ciently cooled before
storing ice cream and foods
cooler than room temperature.
• Do not open the doors more
than necessary, and close
them as soon as possible.
• In summertime, it may
take more than 24 hours to
make ice immediately after
installation.
There may be a plastic
odor.
This odor will gradually
disappear.
Ventilate the room to prevent any
odors from being trapped.
The refrigerator will be
powerfully cooled
(this is the same for
summertime).
• Because heat will radiate out
of the refrigerator in order to
cool its contents, the sides will
become hot.
• Because the compressor will
enter high-speed operation,
the operation sound will grow
loud.
Prepare for Earthquakes
It is recommended to pass
2 strong belts through
the hand-holds on the top
rear of the refrigerator and
anchor them to a strong
location, such as a wall or
post.
Strong
Belts
Do not damage
the refrigerant
circuit (pipes)
or drive screws
into it.
Because combustible
Prohibited
refrigerant is used,
this may result in fi re
or an explosion.
Use in hot spring and
geothermal areas
Corrosion control treatment
may be required for the
refrigerant circuit (pipe) due to
generation of corrosive gases.
Contact the retail store where
you purchased the refrigerator.
Installation
7