Mitsubishi Electric MR-WX627Z Operating Instructions Manual page 29

When attaching parts, use the backward procedures of removal.
Glass Shelf (Upper) (Middle) (Lower)
1 Lift the front of the shelf using both hands.
2 Pull out to the front.
1
* Swiftly pulling out the part to the front can damage the
side of the door. Pull out the part slowly to remove it.
3 Using the gap between the refrigerator compartment and
door, rotate the glass shelf (upper) and remove from the
refrigerator.
* The illustration is of the glass shelf (upper). Remove the
glass shelves (middle) and (lower) in the same manner.
Follow these procedures for MR-WX743Y. For other
models, follow the procedures on the right.
* Remove the glass shelf (lower), with the partition
attached, after you have removed the glass shelf
(middle) and slide glass shelf.
* The illustration is of the MR-WX743Y.
Partition
1 Remove the glass shelf (lower) and place it on a
surface such as a stand.
2 Press the glass shelf (lower) down with one hand.
* The shelves are fi rmly installed.
3 Pull in the direction indicated by the arrow.
Be careful when attaching and
removing the glass shelf.
If it is attached improperly, it could come
Follow the
loose and fall, causing injury.
instructions
2
2
3
Models other than MR-WX743Y glass shelf (lower)
1
Pull out to the front using both hands
until making contact with the tabs.
Lift the front of the shelf to remove the tabs.
Pull out until making
contact
Tab
2
Hold the front and back of the glass
shelf (lower) and pull the back out to
the front of the rail. Lift the front to
make the glass shelf upright.
Backside (in the upright
position)
3
Pull out the right side or left side of
the glass shelf (lower) (in the upright
position of 2 ) to remove from the
refrigerator.
* Remove with the partition attached after
you have removed the glass shelves
(upper) and (middle) and slide glass shelf.
Adjustable Pocket (Large) (Small) /
Bottle Pocket (Large) (Small)
1 Lift up the left and right of the pocket alternately.
* The pockets are fi rmly installed.
2 Pull out to the front.
2
1
Adjustable Pocket
Be careful when attaching and
removing the pocket.
If it is attached improperly, it could come
loose and fall, causing injury.
Follow the
instructions
Slide Glass Shelf (Front) (Back)
1 Remove the slide glass shelf (front) using the protruding
parts in the front and back along with the grooved parts.
Protruding g
Part
Grooved
Part
2 Pull the slide glass shelf (back) out to the front
while holding the front with both hands.
* Swiftly pulling out the part to the front can damage the
side of the door. Pull out the part slowly to remove it.
1
Rail
ront to
2
side of
3
upright
2
1
Bottle Pocket
1
2
Cleaning
29