Mitsubishi Electric MR-WX627Z Operating Instructions Manual page 27

Water Supply Pipe and Tank Holder
Once a month
1
Pull out the water supply
Water
pipe and wipe the tank
Supply Pipe
holder with a clean cloth.
Do not pour water into the tank
holder. Doing so may cause a
malfunction.
Tank Holder
2
Disassemble and wash the parts.
Twist and remove the water supply
pipe.
White minerals or chlorine
accumulation may adhere to the parts,
this is not abnormal. Wash off such
substances and reuse the parts.
Easier to disassemble/assemble when wetted
3
W W W W W W Water Supply W W W W W W W W W
Follow the procedure in
Pipe P
reverse to return the parts
to their original positions.
Push in the water supply pipe fi rmly
so there are no gaps.
If there are gaps or looseness, it may
cause a malfunction.
Tank Holder
4
Check whether there are
Tank
any foreign objects between
Packing
the water supply pipe, tank
packing, and tank holder.
Horizontally
Insert it horizontally so that
there are no gaps.
So that foreign
Failing to do so may cause noises to
objects do not
get inside
occur, ice to not freeze, and may also
cause the water in the water tank or food
Water Supply Pipe
in the refrigerator compartment to freeze.
Notice
If the water supply pipe and tank packing are not installed, they may cause the water in the water tank or food in the refrigerator compartment and sliding cases to freeze.
Replacement is not usually required for the leadcleaning fi lter. However, it may require replacement in the following cases.
˙ When it clogs because something other than water was put in the tank ˙ When it has broken ˙ When mold has grown
To purchase a new fi lter, contact the retail store where you purchased the refrigerator.
* If mold forms easily in certain types of water, clean about 2 or 3 times a week.
6
Install the tank pipe.
1 Insert the tank pipe into the water
tank.
Tank Pipe
Water Tank
Caution
Do not let
foreign objects
block the hole.
1 to 2 times a year
Before cleaning, make sure to set "Stop Ice
Making."
1
will appear on the operation panel.
If the alarm sounds continuously when the ice tray lock
lever is unlocked, lock the lever, close the door, wait for the
blinking
2
Empty the ice tray and wash it.
3
Do not use a sponge or scrubber. A damage may cause
malfunction.
After washing the tray, dry off any moisture.
4
Attach the ice tray.
Push in the ice tray until it makes a clicking sound, and
then lock the ice tray lock lever.
will disappear. If the lamp does not disappear, check
the position of the ice tray lock lever and the up and down
orientation of the ice tray.
Locked
When making ice, set the ice making compartment's setting to
2 Connect the tank pipe to the
water supply pump.
Check that there are no foreign objects
between the tank pipe and the water
supply pump.
Water
Supply
Pump
Tank Pipe
Ice Tray
Pages 21 - 22
Open the door of the ice
making compartment
and unlock the ice tray
lo lock lever.
Ice Tray Lock Lever
to turn off, and then try again.
Pull the ice tray towards the
front and then remove it.
There is a risk of the water
spilling. Pull out the tray slowly.
Unlocked
3 Install the tank packing
Tank Packing
.
Pages 21 - 22
Cleaning
27