Acer Veriton 3000 Service Manual page 100

CPU Clock Mismatch
DMI Table Was Destroyed
Equipment Configuration Error
Floppy Disk Controller Error
Floppy Drive A Error
Floppy Drive B Error
Floppy Drive(s) Write Protected
Hard Disk Drive(s) Write Protected
I/O Parity Error
IDE Drive 0 Error
IDE Drive 1 Error
IDE Drive 2 Error
IDE Drive 3 Error
Insert system diskette and press <Enter> key to reboot
IRQ Setting Error
Expansion ROM Allocation Fail
I/O Resource Conflict(s)
Memory Resource Conflict(s)
On Board Parallel Port Conflict(s)
On Board Serial Port 1 Conflict(s)
On Board Serial Port 2 Conflict(s)
Onboard xxx... Conflict(s)
PCI Device Error
Press Ctrl + Alt + Esc key to enter Setup or F1 key to
continue
Press Esc to turn off NMI, or any key to reboot
PS/2 Keyboard Error or Keyboard Not Connected
PS/2 Keyboard Interface Error
PS/2 Keyboard Locked
PS/2 Pointing Device Interface Error
PS/2 Pointing Device Error
68
BIOS Message Action/FRU
1. Enter BIOS Setup and load the default settings.
2. Ensure that the BIOS setting for the processor is set
correctly.
1. Flash the BIOS.
1. Ensure that the system configuration set in BIOS Setup
is correct.
2. Enter BIOS Setup and load the default settings.
3. RTC battery.
4. Main board.
1. Diskette drive cable/connection.
2. Diskette drive.
3. Main board
1. Ensure that the diskette drive is not set to [Write
protect] in the Security Options in BIOS Setup.
2. Load default settings in Setup.
1. Main board.
1. Enter BIOS Setup and load the default settings.
2. Check the IDE drive jumper.
3. IDE hard disk drive power.
4. IDE hard disk drive cable/connection.
5. IDE hard disk drive.
1. Insert a bootable disk into the floppy disk drive or
remove this disk if a hard disk is installed.
1. Load default settings in Setup.
2. Enter BIOS Setup and set the Reset Resource
Assignments of the PnP/PCI Options to Yes;
then reboot the system.
3. Remove all adapter cards that are NOT factory-
installed and then reboot the system.
1. Enter BIOS Setup and load the default settings.
2. Remove all adapter cards that are NOT factory-
installed and then reboot the system.
1. Enter BIOS Setup and load the default settings.
2. Remove all adapter cards that are NOT factory-
installed and then reboot the system.
1. Load default settings in Setup.
2. Enter BIOS Setup and set the Reset Resource
Assignments of the PnP/PCI Options to Yes,
then reboot the system.
3. Remove all adapter cards that are NOT factory-
installed and then reboot the system.
1. Press Ctrl+Alt+Esc to enter Setup and reconfigure the
system.
1. Press Esc to reject the NMI error or press any other
key to reboot the system.
1. Reconnect the PS/2 keyboard and mouse.
2. Enter BIOS Setup and load the default settings.
3. PS/2 keyboard.
4. PS/2 mouse.
5. Main board.
1. Reconnect the PS/2 keyboard and mouse.
2. Enter BIOS Setup and load the default settings.
3. PS/2 mouse.
4. PS/2 keyboard.
5. Main board.
Chapter 4