2.2.2 Connecting to a Car with 12VDC
Glove box (inside or underneath)
Driver seat (between the seat and side panel)
Vehicle Battery
12V
Note:
1. If the car is without an ignition key, please connect the IGN (yellow) wire directly or
via a switch to the vehicle battery.
2. It is suggested to use a relay in the installation. Otherwise, the AI mobile NVR will
always draw the power from the vehicle battery.
Passenger seat (underneath)
Relay (12V)
+
Key Start /
Switch
-
GND (Black)
eNVP-JNN-IV-V0008 / eNVP-JNX-IV-V0008
Trunk
12V+ GND IGN
Red
12V+ (Red)
IGN (Yellow)
9
Black Yellow
Fuse (10A)
Power Harness Cable