Insert Battery; Notes On Measurement - LaserLiner BBQ-GasCheck Instruction Manual

– Observe the safety regulations for handling propane/butane
gas cylinders.
– The measurement is not a substitute for correct residual gas
disposal.

Insert battery

1
Open the battery compartment on
the housing's rear side and insert a
9V battery. Correct polarity must be
observed.
The device is ready for use immediately once the batteries
!
have been inserted. It does not have a separate ON/OFF
switch and is therefore always active.

Notes on measurement

– Depending on the propane/butane mix ratio and the temperature,
steel and aluminium gas cylinders are normally filled up to 80%.
– The measuring device is not suitable for use on plastic gas bottles.
– The measurement can be adversely affected by dirt on the
measuring head and gas cylinder. The measuring surfaces should
therefore be cleaned with a damp cloth.
– Possible influencing factors on gas cylinders include:
1.Rust (also invisible areas on the inside)
2. Uneven/excessively thick coating on the outer wall
3. Ice build-up on the surface
4. Dented or scratches surfaces
5. Radii of upper and lower ends of gas cylinders too small
To avoid these factors, the measurement should be carried out at
several points in the cleaned central area of the gas cylinder.
– To avoid sloping liquid levels, the gas cylinder should be as upright
as possible during the measurement.
– It is recommended to start the measurement from the bottom in
order to determine the minimum level as fast as possible.
– The exact level is at the point between the signals „Gas"
and „No Gas".
– Measurement is not possible on welded seams.
BBQ-GasCheck
07
EN