HITCH BALL
PLACEMENT
WELD SPOTS
Insert the assembled Ball Mount
into the Hitch and lock as normal.
Make sure the Weld Spots on
the Hitch Ball are pointed towards
the rear left side of your trailer
at about 10 o'clock.
TIGHTEN THE
BALL MOUNT
TIGHTENING BAR
Once the Ball Mount is secure,
use the Tightening Bar to ensure
the connection is as tight as possible!
This will take a few rotations.
HITCH CONNECTION
FLUSH,
Turn the Ball Mount Counterclockwise
until the gap between the Ball Mount
TIGHT,
Collar and Trailer Tongue closes
NO GAP
tightly, with no gap.
Have a Gap or Step Down Hitch
preventing a flush connection?
SEE PAGE 9
8