AEG IPE64551FB User Manual page 17

Problem
You cannot select the maxi-
mum heat setting for one of
the cooking zones.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
Hob²Hood does not work.
The sensor fields become
hot.
There is no sound when you
touch the panel sensor
fields.
Possible cause
The fuse is blown.
You do not set the heat set-
ting for 50 seconds.
You touched 2 or more sen-
sor fields at the same time.
Pause operates.
There is water or fat stains
on the control panel.
The other zones consume
the maximum available pow-
er.
Your hob works properly.
You put something on one
or more sensor fields.
You put something on the
sensor field .
The zone is not hot because
it operated only for a short
time or the sensor is dam-
aged.
You covered the control
panel.
You use a very tall pot which
blocks the signal.
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated.
ENGLISH
Remedy
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Activate the hob again and
set the heat setting in less
than 50 seconds.
Touch only one sensor field.
Refer to "Daily use".
Clean the control panel.
Reduce the heat setting of
the other cooking zones
connected to the same
phase.
Refer to "Power manage-
ment".
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Remove the object from the
control panel.
Use a smaller pot, change
the cooking zone or operate
the hood manually.
Put large cookware on the
rear zones, if possible.
Activate the sounds. Refer to
"Daily use".
17