Assignment Of The Function Keys - Conrad Electronic ST50-D 50W Operating Instructions Manual

Make sure the soldering contacts of the workpiece
are clean.
- Cover the heated soldering tip with solder. Wipe off excess solder
on the damp cleaning sponge.
- Heat the soldering spot and add solder.
- Let the soldering spot cool off.
- Clean the soldering tip on the damp sponge after each soldering work.
- After you have finished the soldering work, place the soldering
iron into the support and turn the soldering station off at the ope-
rating switch.
- Do not file the soldering tip as this destroys it.
Allow the soldering iron to cool down after use.
Never submerge in water.

Assignment of the function keys

The digital soldering stations allows you to save three frequently
used temperature settings on the three function keys. This avoids
having to set the temperature via the control.
The keys were pre-programmed by the factory and can be assigned
freely.
For reassigning values, proceed as follows.
- Press the desired PRESET key and keep it depressed.
- The display shows the following after
approx. three seconds (PS2 = PRESET 2)
- Set the desired temperature with the tem-
perature control.
- The top value behind PS1 / PS2 / PS3 shows the nominal tempe-
rature for the respective memory slot.
- After letting go of the PRESET button, the new value is saved.
Repeat this for the other buttons.
- The saved values are also preserved after turning the station off.
24