Table of Contents
Advertisement
Installation
The dishwasher must be level to ensure correct closure and sealing of the door. When the unit
is correctly levelled, the door should not catch the inner liner on either side of the cabinet. The
adjustable feet may be loosened or tightened in order to obtain the optimum levelling of the
unit. The back foot can be adjusted by turning the cross headed screw that is located in the
centre on the base of the unit with a cross headed screwdriver. The front feet can be adjusted
by turning them with a flat headed screwdriver or by hand. Note: the maximum height the
feet can be adjusted is 50mm
Do not connect the unit to the mains socket before installation. Ensure you are not
installing the unit right in front of the mains socket. This is to avoid potential damage to
the back of the unit.
The condensation strip must be fitted to the underside of the worktop above your dishwasher
to protect it against any moisture. Its purpose is to protect your worktop's underside from
steam rising from the dishwasher. Remove the backing paper from the condensation strip
(accessory 6) and stick the condensation strip to the underside of the worktop. Ensure the
surface is clean prior to sticking the condensation strip to the underside of the worktop. Failure
to attach the condensation strip could result in damage to the underside of your worktop.
Condensation strip
For Customer Services & Spare Parts please call 0345 208 8750
Opening times: Monday - Friday 8am – 8pm & Saturday 9am – 1pm
or visit us at www.productcare.co.uk
30
Advertisement
Table of Contents
