Air Conditioner Operations And Performance - Pioneer UB018 Owner's Manual

MANUAL
Temperature Indicator
Infrared Signal Receiver
NOTE:DEF Indicator (cooling and heating-type)
or FAN Indicator (cooling-only type)
Display Panel Fig. 2-4
NOTE:DEF Indicator (cooling and heating-type)
or FAN Indicator (cooling-only type)
MANUAL
OPERATION TIMER
Display Panel Fig. 2-5
NOTE:DEF indicator (cooling and heating-type)
or FAN Indicator (cooling-only type)
MANUAL
TIMER
OPERATION
Display Panel Fig. 2-6
PRE-DEF Indicator (cooling and heating-
type)
or Fan-Only Indicator (cooling-only type)
Infrared Signal Receiver
Operation Lamp
Timer Indicator Alarm Indicator
Display Panel Fig. 2-7
PRE-DEF Indicator (cooling and heating-
type)
or Fan-Only Indicator (cooling-only type)
Infrared Signal Receiver
Operation Lamp
Timer Indicator Alarm Indicator
Display Panel Fig. 2-8
For the inverter type, this switch is used for after-sales service
purposes only. Users should not touch it.
OPERATION
TIMER
DEF./FAN
ALARM
Infrared Signal Receiver
DEF./FAN ALARM
Infrared Signal Receiver
DEF./FAN ALARM
Temporary Button
MANUAL
Temperature Indicator
Temporary Button
FUNC
Temperature Indicator
For the fixed-frequency type, this function is used to operate the
unit temporarily, the remote controller is misplaced, or its
batteries have ben exhausted. Two modes, including
AUTO and FORCED COOL, can be selected through the
TEMPORARY BUTTON on the air-in grill control box of the indoor
unit. Once you push this button, the air conditioner will run in the
following order: FORCED AUTO, FORCED COOL, OFF, and
back to FORCED AUTO.
1 FORCED AUTO
The OPERATION lamp is lit, and the air conditioner will run
under FORCED AUTO mode. The remote controller operation is
enabled to function according to the received signal.
2
FORCED COOL
The OPERATION lamp flashes, the air conditioner will turn to
FORCED AUTO after it is set to cool with a wind speed of HIGH
for 30 minutes. The remote controller operation is disabled.
OFF
3
The OPERATION lamp goes off. The air conditioner is OFF,
while the remote controller operation is enabled.
NOTE
This manual does not include Remote Controller
Operations, see the "Remote Controller Owner's
manual", which is packed with the unit, for further details.
3. AIR CONDITIONER OPERATIONS AND
PERFORMANCE
Use the system with the following temperatures for safe
and effective operation. The max operation temperatures
for the air conditioner is listed. (Cooling/Heating)
Table 3-1
Temperature
Mode
0°C ~ 50°C / 32 °F~122°F
-15°C ~ 50°C / 5 °F~122°F
Cooling Operation
(for the models with low
temperature cooling system)
Heating Operation
-25°C ~ 24°C / -12 °F~76°F
(Inverter++ Models)
Drying Operation 0°C ~ 50°C / 32 °F~122°F
NOTE
1
If the air conditioner is used outside the above conditions, it
may cause the unit to function abnormally.
The phenomenon of when the surface of the air conditioning
2
unit condenses with water is normal when there is a larger
relative humidity in room. Please close doors and windows.
Optimal performance will be only be achieved when within
3
these operating temperature ranges.
FORCED
Outdoor
Temperature Temperature
17°C ~ 32°C
( 62 °F ~ 90°F)
0°C ~ 30°C / 32 °F~86°F
17°C ~ 32°C
( 62 °F ~ 90°F)
owner's manual
3