Outdoor Unit Installation; Outdoor Unit Installation Instructions; Air Evacuation - Pioneer YN-M Series Installation Manual

Outdoor Unit Installation

Outdoor Unit Installation Instructions

Step 1: Select installation location.
The outdoor unit should be installed at a location
in accordance with the following guidelines:
 Place the outdoor unit as close to the indoor
√
units as possible.
 Ensure that there is enough room for
√
installation and maintenance.
The air inlet and outlet must not be
 √
obstructed or exposed to strong winds.
 Ensure the location of the unit will not be
√
subject to snowdrifts, accumulation of leaves,
or other seasonal debris. If possible, provide
an awning for the unit. Ensure the awning
does not obstruct the airflow.
 The installation area must be dry and well
√
ventilated.
 There must be enough room to install the
√
connecting pipes and cables, and to access
them for maintenance.
Strong wind
Fig. 6.1
Step 2: Install outdoor unit.
Fix the outdoor unit with anchor bolts (M10 or 3/8")
>60cm / 24"
Fig. 6.3
Strong wind
(Alternatively, use condenser
Wall Mounting Brackets)
Fix with bolts
 The area must be free of combustible gases
√
and chemicals.

√
The pipe length between the outdoor and
indoor unit may not exceed the maximum
allowable pipe length.
 If possible, DO NOT install the unit where it
√
is exposed to direct sunlight.
 √ If possible, make sure the unit is located far
away from your neighbors' property so that
the noise from the unit will not disturb them.
 If the location is exposed to strong winds (for
√
example: near a seaside), the unit must be
placed against the wall to shelter it from the
wind. If necessary, use an awning.
(See Fig. 6.1 & 6.2)
 √ Install the indoor and outdoor units, cables
and wires at least 1 meter from televisions or
radios to prevent static or image distortion.
Depending on the radio waves, a 1m (3')
distance may not be enough to eliminate all
interference.
Fig. 6.2
CAUTION
Be sure to remove any obstacles that
•
may block air circulation.
Make sure you refer to length
•
specifications to ensure there is
enough room for installation and
maintenance.
6
Minimum clearance
needed in front of the
unit is 2m (80 Inches)
Strong wind
 
Page 9