Wideband Ir - A-Neuvideo ANI-HDR-100 Instruction Manual

A NEUVIDEO
Wideband IR (30KHz---60KHz) introduction
IR RECEIVER (RX):
• To control the source: Plug IR Receiver into the IR RX port of the receiver unit; place the receiver at or near the display.
• To control the display: Plug the IR Receiver into IR RX port of the transmitter unit; place the receiver in position where it is able to
receive remote signals.
IR BLASTER (TX):
• To control the source: Plug the IR Blaster into IR TX port of the transmitter unit; place the blaster in front of the IR eye of the source.
• To control the display: Plug the IR Blaster into IR TX port of the receiver unit; place the blaster in front of the IR eye of the display.
9
CONNECT & OPERATE