Page 2
SAFETY INFORMATION To ensure the best results from this product, please read this manual and all other documentation before operating your equipment. Retain all documentation for future reference. Follow all instructions printed on unit chassis for proper operation. To reduce the risk of fire, do not spill water or other liquids into or on the unit, or operate the unit while standing in liquid. Make sure power outlets conform to the power requirements listed on the back of the unit.
• Never push an object of any kind into this product through any openings or empty slots in the unit, as you may damage parts The ANI-HDR-100 18Gbps HDMI Extender is a tool which can inside the unit. extend your HDMI signal over 328ft (100M) to a compatible display.
NEUVIDEO FEATURES & cable termination FEATURES • HDMI 2.0b (18Gbps), HDCP 2.2 and DVI compliant • Video resolutions up to 4K2K@50/60Hz (YUV444) • 10bits HDR (High Dynamic Range) pass through • Supports HDMI High Bit Rate (HBR) audio pass through •...
NEUVIDEO OPERATION CONTROLS & FUNCTIONS Transmitter POWER LED: System power indicator. DC 24V: Connect the 24V/1A adaptor to the AC wall outlet for power. HDBaseT™ OUT: Standard HDBaseT signal output port. Connects the HDBaseT receiver with a UTP cable following the standard ™...
Page 7
NEUVIDEO OPERATION CONTROLS & FUNCTIONS Receiver POWER LED: System power indicator. DC 24V: Connect the 24V/1A adaptor to the AC wall outlet for power. HDBaseT™ IN: Standard HDBaseT signal input port. Connects the HDBaseT Transmitter with a UTP cable following the standard ™...
NEUVIDEO Description Description 1 POC (Power Over Cable) Application Example Description 2 Bidirectional Infrared Control Application Example Description 3 Bidirectional RS-232 Control Application Example...
NEUVIDEO CONNECT & OPERATE Wideband IR (30KHz---60KHz) introduction IR RECEIVER (RX): • To control the source: Plug IR Receiver into the IR RX port of the receiver unit; place the receiver at or near the display. • To control the display: Plug the IR Receiver into IR RX port of the transmitter unit; place the receiver in position where it is able to receive remote signals.
Page 12
BY, THROUGH OR UNDER A-NeuVideo, INC (COLLECTIVELY, THE “PRODUCT”). By using installing or using the Product, you unconditionally signify your agreement to these Terms and Conditions. If you do not agree to these Terms and Conditions, do not use the Product and return the Product to A-NeuVideo, Inc. at the return address set forth on the Product’s packing label at your expense.