Table of Contents
Advertisement
(Continued from previous page)
Current Network Configuration
Interface eth0
Host name:
Using DHCP:
Interface eth1
Host name:
Using DHCP:
Host IP address:
Network mask:
Gateway IP address:
Speed:
DNS servers
Primary DNS:
Secondary DNS:
--------------------------
Network Configuration Menu
--------------------------
eth0
Configure Control Port IP
eth1
Configure Feature Port IP
dns
Configure DNS
exit
Exit network configuration
Choose item to modify >
3. Either:
• Continue with step 4 for information on modifying the IP configuration of either the Control
Port or the Feature Port.
• Go to step 10 for information on modifying the DNS configuration.
• To exit the Network Configuration Menu without modifying any settings, type exit at the
Network Configuration Menu > prompt.
4. Type eth0 or eth1, as applicable, and press Enter to modify the configuration of the
Control Port or the Feature Port, respectively.
5. At the Host name [pcs200s]: prompt, either press Enter to accept the default value in
square brackets, or type a new host name and then press Enter.
6. (Control Port configuration only) At the Using DHCP (Y/N) [Y]: prompt, type y to use
DHCP, or type n to specify the network IP addresses. Then, press Enter.
206-4270
PCS200S Configuration Options (Cont.)
pcs200s
YES
pcs200s
NO
1000Mbps
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
(Continued on next page)
23
Advertisement
Table of Contents
