Lubricating Grease Fitting [2Wd Model]; Every 600 Hours; Adjusting Front Axle Pivot; Every 800 Hours - Kubota MX4800 Operator's Manual

(1) O ring
(2) Element
(3) Spring
(4) Red float
(5) Cup
(6) Retainer ring
BLubricating Grease Fitting [2WD Model]
Detach the cover, and apply bearing grease.
(1) Front wheel hub cover
PERIODIC SERVICE

EVERY 600 HOURS

BAdjusting Front Axle Pivot
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Loosen the lock nut, screw-in the adjusting screw until
seated, then tighten the screw with an additional 1/6 turn.
Re-tighten the lock nut.
(1) Adjusting screw
(2) Lock nut

EVERY 800 HOURS

BChanging Front Axle Case Oil
[4WD]
1. To drain the used oil, remove the right and left drain
plugs and filling plug at the front axle case and drain
the oil completely into the oil pan.
2. After draining reinstall the drain plugs.
3. Remove the oil level check plug.
4. Fill with the new oil up to the check plug port.
(See "LUBRICANTS" in "MAINTENANCE" section.)
5. After filling reinstall the filling plug and check plug.
Oil capacity
85
8.5 L (8.9 U.S.qts.)