Table of Contents
Advertisement
18
www.electrolux.com
2. Pull the rear end of the shelf support
away from the side wall and remove it.
1
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must point
to the front.
10.4 Catalytic cleaning
CAUTION!
Do not clean the catalytic
surface with oven sprays,
abrasive cleaning agents, soap
or other cleaning agents. This
will damage the catalytic
surface.
Spots or discolouration of the
catalytic surface have no effect
on catalytic properties.
WARNING!
Keep children away when you
clean the oven at a high
temperature. The oven surface
becomes very hot and there is
a risk of burns.
CAUTION!
Always turn the oven light on
while using the catalytic
cleaning (if applicable).
Before activating the catalytic
cleaning remove all the
accessories from the oven.
The walls with a catalytic coating are self-
cleaning. They absorb fat which collects
on the walls while the appliance operates.
To support the self-cleaning procedure,
heat the empty oven on a regular basis.
2
1. Clean the oven floor with warm water
and washing up liquid, then dry it.
2. Set the function
set
.
3. Set the temperature to 250ºC and let
oven operate for 1 hour.
4. When the appliance is cool, clean it
with a soft and moist sponge.
10.5 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of
glass panels is different for different
models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on
the two door hinges.
A
3. Close the door until it is at an angle of
approximately 45°.
45°
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
if applicable. If not,
A
Advertisement
Table of Contents
