Titan PGD2000 Operator's Manual page 9

Refueling
•
Always turn the engine off and allow adequate time for it to cool before refueling. ONLY USE
UNLEADED FUEL WITH 86 OCTANE OR HIGHER.
•
NEVER refuel your driver with the engine hot, running, or in an unventilated area. Fuel vapors
are extremely flammable and can cause severe injury or death if ignited by a spark or
excessive heat from a hot engine.
•
Fill the tank on level ground and avoid spilling the fuel on the motor. Always allow any spilled
fuel to evaporate before restarting the engine.
•
Ensure the fuel cap is adequately tightened before restarting the engine.
Installing the Adapter Sleeve
• A 1" adapter sleeve is included with each PGD2000 Post Driver and a 2" adapter sleeve is
included with each PGD3200 Post Driver.
•
To install the adapter sleeve, simply press the narrow end of the reducer sleeve into the barrel.
•
For ease of inserting/removing, only use half of the rubber pads with your reducer sleeve. For
the most secure fit, use all eight rubber pads with your reducer sleeve.
•
Additional sleeve sizes are available for both the PGD2000 and PGD3200 Post Drivers.
9