MELAG Pro-Clas Quick Start Manual

Tools required: Torx key TX20, Socket Allen key 3 mm

Some components of the power electronics and other components remain live even after the power

switch has been switched off. Remove the mains plug.

Remove the semi-circular cover on the door interior

panel by removing both Torx screws (Fig. 1).

Remove both Torx screws for fixing the locking slider

on the inside of the door (Fig. 2) and remove the

locking slider from the door exterior. Pay attention to

the spacer plates, which are hanging loose on the

retaining collars (Fig. 3, detail).

AS_013-13_EN_ProClass_SClass_v0.docx

Fig. 1

Fig. 2

Fig. 3

Rev.: 0 – 13/139

Removing the door panel

Pro-Class, S-Class

Table of Contents

Do you have a question about the Pro-Clas and is the answer not in the manual?

Page 1 Removing the door panel Pro-Class, S-Class Instructions for removing the door panel Tools required: Torx key TX20, Socket Allen key 3 mm WARNING Some components of the power electronics and other components remain live even after the power switch has been switched off. Remove the mains plug. Remove the semi-circular cover on the door interior panel by removing both Torx screws (Fig.
Page 2 Removing the door panel Pro-Class, S-Class The door panel is fixed to the door interior by the four screws. Use the socket Allen key to loosen the upper and lower hexagon screws slightly and remove the plastic door panel forwards. Fig.

S-class