Controlling The Projector Through A Lan Environment - ViewSonic PG800X User Manual

Controlling the projector through a LAN
environment
The projector supports Crestron
Settings menu, you can manage the projector from a computer using a web browser when
the computer and the projector are properly connected to the same local area network.
Configuring the LAN Control Settings
If you are in a DHCP environment:
1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector
and the other end to the RJ45 port.
2. Open the OSD menu and go to the ADVANCED > LAN Control Settings menu.
3. Press Enter. The LAN Control Settings page is displayed.
4. Highlight LAN Settings and press
5. Press to highlight Apply and press Enter.
6. Please wait for around 15 - 20 seconds, and then re-enter the LAN Control Settings
page. The Projector IP Address, Subnet Mask, Default Gateway, and DNS Server
settings will be displayed. Note down the IP address displayed in the Projector IP
Address row.
If the Projector IP Address still does not appear, contact your network administrator.
If the RJ45 cables are not properly connected, the Projector IP Address, Subnet Mask, Default
Gateway, and DNS Server settings will display 0.0.0.0. Make sure the cables are properly
connected and perform the procedures above again.
If you need to connect to the projector in its standby mode, set Standby LAN Control to On in
the ADVANCED > LAN Control Settings menu.
If you are in a non-DHCP environment:
1. Repeat steps 1-3 above.
2. Highlight LAN Settings and press
3. Contact your ITS administrator for information on the Projector IP Address, Subnet
Mask, Default Gateway, and DNS Server settings.
4. Press to select the item you want to modify and press Enter.
5. Press /
6. To save the settings, press Enter. If you do not want to save the settings, press Exit.
7. Press to highlight Apply and press Enter.
®
software. With correct settings for the LAN Control
(An example of connection)
to move the cursor and the press
38
/ to select DHCP ON.
/ to select Static IP.
/ to enter the value.