Toshiba RAS-25J2KVSG-ND Service Manual page 110

No. Part name
Heat exchanger 1) Follow the procedure in item 3 and 4 .
10
(Evaporator) 2) Remove 2 fixing screws at the left side of
3) Remove fixing screw at the upper right side
4) Remove the pipe holder from the rear side of
5) Pull out the right hand side until the locking
<To re-installation>
- Please make sure that the hook of motor cover
Procedures
the heat exchanger.
of the heat exchanger.
the main unit.
slot of heat exchanger is released from the
hook of the motor cover then pull out the
upper side of heat exchanger.
Heat exchanger
must be installed into the locking slot of
heat exchanger.
Heat exchanger
Motor cover
Locking
slot
Hook
Heat exchanger
Motor cover
Locking slot
Hook
- 110 -
Remarks
Screws
Heat exchanger
Screw
Pipe holder
Heat exchanger