Yaesu FT-4XE Advance Manual page 30

31 RPT.SFT
Sets the repeater shift direction.
SIMPLX
-RPT
+RPT
See the Operating Manual for details.
32 RXSAVE
Selects the Receivemode Battery Saver interval ("sleep" ratio)
200 MS - 2 SEC
OFF
33 SCN.LMP
Turns the scan lamp ON/OFF while paused.
ON
OFF
34 SCN.RSM
Configures the scan stop mode settings.
BUSY
HOLD
TIME
See the Operating Manual for details.
35 SKIP
Selects the Memory Scan "Skip" channel-selection mode.
OFF
SKIP
No TX frequency offset.
Shifts TX to a lower frequency.
Shifts TX to a higher frequency.
Enables the battery save function. Receiving is automatically
OFF during the set time, no signal is heard.
Disables the Battery save function.
When stops scanning temporarily, the back light turns ON.
The back light does not illuminate when scan stops.
The scanner will halt on a signal it encounters. Scanning will
resume one second after the other station signal ceases trans-
mitting. In the case of constant-carrier signals like Weather
Station broadcasts, the scanner will likely remain on this fre-
quency indefinitely.
The scanner will halt on a signal it encounters. Scanning will
only resume when it is manually re-initiated.
The scanner will halt on a signal it encounters, scanning will
resume after five seconds even if a signal is still on the fre-
quency. To cancel scanning, press the the PTT switch, [▲] or
[▼] key.
All memory channels will be scanned (the "flag" will be ig-
nored).
The scanner will "skip" the flagged channels during scanning.
30