Airfl Ow Direction Adjustment - Mitsubishi Heavy Industries SKM20ZSP-S User Manual

Airfl ow direction adjustment
■ Up/down direction can be adjusted with the AIRFLOW button on the remote control. Every time you press this button the mode
changes as follows:
Change on AIRFLOW (UP/DOWN) mode.
NOTE FOR HEATING OPERATION
• When operation starts, the fl ap direction is fi xed at the horizontal position in order to avoid cold draft, and return to the set the position that was set after
the warm air supply is starting.
• The fl ap direction will be controlled to the horizontal position when the room temperature reaches the set temperature and compressor stops or when
defrosting is in operation.
• The airfl ow direction cannot be set during the period mentioned above. Change the airfl ow direction settings after the warm air is supplied and the fl ap
goes to the set position.
MEMORY FLAP (FLAP STOPPED)
When you press the AIRFLOW button once while the fl ap is operating, it stops swinging at the
position. Since this angle is memorized in the microcomputer, the fl ap will automatically be set at
this angle when the next operation is started.
• Do not expose directly to airfl ow from the air-conditioner for a long time.
• When in COOL or DRY operation, do not operate for a long period with the
airfl ow blowing straight down. Otherwise, condensation may appear on the
outlet grill and drip down.
• Do not try to adjust the fl aps by hand, as the control angle may change or
the fl ap may not be closed completely.
■ Adjust the direction by moving the left/right louver by hand.
When you adjust the direction, touch the operation point of louver.
• Please stop the air conditioner when adjusting the air fl ow direction.
Adjusting airfl ow direction
(Flap stopped)
WARNING
CAUTION
Adjusting left/right air fl ow direction
CAUTION
– 12 –
(Swing)
• Recommended angle of the fl ap when stopping
HEAT
COOL, DRY
Operation point
Louver
Flap
(Slant forward
blowing)
(Horizontal
blowing)