EasyIO FS Series User Manual page 8

FG Series Modbus Slave v1.0
Step 3
Choose easyioFGMbSlave from Sedona Palette
Drag & drop the ModbusSlaveSerialNetwork into your App. The object can be dropped in the EasyIO folder or a
new folder can be created for the Serial Network Object.
In the example below, the object is dropped into a new folder named "Modbus".
Step 4
Double click the object to access the property sheet.
Configuration of the RTU network parameters such as baud rate, parity etc is carried out here.
The device address on the serial networkis set in this property.
When complete and all serial network and operational parameters are entered correctly and complete enable the
network.
Please ensure the "D2" terminal set is used for the serial network connection and observe the correct polarity.
Step 5
Drop any Modbus "serial" register type object under the Network Object.
Note that the register object must be a child of (dropped below) the Network object. It is possible to create folders
below the Network Object to allow logical management of the register objects.
8