Changing The Card Settings - Fujitsu GP5-FC102 User Manual

After Fast! UTIL has started up, the following menu appears on screen.
5.2 Changing the card settings
Selecting "Configuration Settings" from the menu causes another menu to appear.
With the options in this menu, you can check and change the card settings.
Here are the available options and their functions.
Note
Don't change the settings unless so instructed by the user's guide for the
device you want to connect, etc.
Host Adapter Settings
Selectable Boot Settings
Restore Default Settings
Raw Nvram Data
Advanced Adapter Settings
Extended Firmware Settings
Selecting "Host Adapter Settings", "Advanced Adapter Settings", or "Extended
Firmware Settings" displays a list of the current settings.
To make a change to a setting, move the cursor to it and press the Enter key.
To exit this setting mode, press the Esc key.
Configuration Settings
Scan Fibre Devices
Fibre Disk Utility
Select Host Adapter
Exit Fast!UTIL
Options
Allows you to set the operating conditions of the
card.
Allows you to select the startup device if you
want to boot up the system from the device
connected to the fibre channel. This option
cannot be used with the supplied card.
Initializes the card. Do not execute this, because
the settings change.
Displays the settings recorded on the NVRAM in
hexadecimal notation.
Allows you to set the operation conditions of the
card.
Fig. 3
Functions
E
7