Woods BRUSHBULL BB48 Operator's Manual page 34

Install Tailwheel
1. Attach tailwheel bracket (6) to cutter at the
tailwheel pivot holes (5B) using cap screw (13) and
flange lock nut (14) previously removed.
NOTE: Make sure grease fitting on tube is on top
when installing tailwheel.
2. Select desired height adjustment holes (10), and
secure tailwheel bracket with cap screws (13) and
flange lock nuts (14). Cutting height adjustment will
be necessary when cutter is fully assembled. See
page 9.
3. Raise rear of cutter and insert tailwheel assembly
(9) into tailwheel bracket (6). Secure with washer
(37) and spiral pin (28).
4. Place diagonal brace bars (4) on the inside of
frame rails and attach to diagonal brace mounting
holes (5A). Secure using cap screws (13) and
flange lock nuts (14).
37
28
6
14
9
13
10
5B
13
5A 4
4. Diagonal brace bar
5A. Diagonal brace mounting hole
5B. Tailwheel pivot hole
6. Tailwheel bracket
9. Tailwheel assembly
10. Cutting height bracket
13. 5/8 NC x 2 Cap screw
14. 5/8 NC Flange lock nut
28. Spirol pin
37. 33 mm Flat washer
Figure 26. Tail Wheel Installation
30 Assembly
13
13
6
14
CD6335B
Install A-Frame
BB48 & BB60 Cutters: Attach A-frame bars (2) to the
inside of front mast plates. Secure into position using
carriage bolts (15), sleeves (16), flat washers (17), and
flange lock nuts (14).
2. A-frame bar
14. 5/8 NC Flange lock nut
15. 5/8 NC x 2 Carriage bolt
16. 5/8 x 1-9/16 Sleeve
17. 5/8 Flat washer
15
CD6336
Figure 27. BB48 and BB60 Only Assembly
BB72 & BB84 Cutters: A-frame bars (2) are already
attached to the front mast plates. Rotate up for connec-
tion to diagonal brace bars.
2. A-frame bar
14. 5/8 NC Flange lock nut
15. 5/8 NC x 2 Carriage bolt
16. 5/8 x 1-9/16 Sleeve
17. 5/8 Flat washer
15
CD6337
Figure 28. BB72 and BB84 Only Assembly
2
16 1
17
16
15
Check Chain
Holes
2
2
16
17
16
15
Check Chain
Holes
(Rev. 5/13/2005)
MAN0050 (Rev. 1/16/2004)