Woods BRUSHBULL BB48 Operator's Manual page 11

SAFETY & INSTRUCTIONAL DECALS
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
BE CAREFUL!
Use a clean, damp cloth to clean safety decals.
Avoid spraying too close to decals when using a
pressure washer; high-pressure water can enter
through very small scratches or under edges of
decals causing them to peel or come off.
Replacement safety decals can be ordered free
from your Woods dealer. To locate your nearest
dealer, check the Dealer Locator at
www.WoodsEquipment.com, or in the United
States and Canada call 1-800-319-6637.
7 - PN 1004114
DANG NGER ER
If shaft connection is visible, shield
is missing. Replace shield before
operating equipment.
10 - PN 33347
DAN ER
UARD MISSIN .
DO NOT OPERATE.
DAN ER
UARD MISSIN .
DO NOT OPERATE.
33347E
DAN ER
(Rev. 5/13/2005)
MAN0050 (Rev. 1/16/2004)
Replace Immediately If Damaged!
1004114
2 - 1006681
WARNING
CRUSHING AND PINCHING HAZARD
Be extremely careful handling various parts of the machine.
They are heavy and hands, fingers, feet, and other body parts
could be crushed or pinched between tractor and implement.
Operate tractor controls from tractor seat only.
Do not stand between tractor and implement when tractor is
in gear.
Make sure parking brake is engaged before going between
tractor and implement.
Stand clear of machine while in operation or when it is being
raised or lowered.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD
RESULT IN SERIOUS INJURY OR DEATH.
WARNING
TO AVOID SERIOUS INJURY OR DEATH:
Read Operator's Manual (available from dealer) and follow all
safety precautions.
Keep all shields in place and in good condition.
Operate mower from tractor seat only.
Lower mower, stop engine and remove key before
dismounting tractor.
Allow no children or untrained persons to operate equipment.
Do not transport towed or semi-mounted units over 20 mph.
FAILURE TO OPERATE SAFELY CAN
RESULT IN INJURY OR DEATH.
WARNING
FALLING OFF CAN RESULT IN BEING RUN OVER.
Tractor must be equipped with ROPS (or ROPS CAB) and seat
belt. Keep foldable ROPS systems in "locked up" position at
all times.
Buckle Up! Keep seat belt securely fastened.
Allow no riders.
RAISED EQUIPMENT CAN DROP AND CRUSH.
Before working underneath, follow all instructions and safety
rules in operator's manual and securely block up all corners
of equipment with jack stands.
Securely blocking prevents equipment from dropping from
hydraulic leakdown, hydraulic system failures or mechanical
component failures.
FALLING OFF OR FAILING TO BLOCK SECURELY CAN RESULT
IN SERIOUS INJURY OR DEATH.
WARNING
DO NOT EXCEED PTO SPEED OF
540 RPM
PTO speeds higher than 540 RPM can cause
equipment failure and personal injury.
1006681
Safety 7