Subaru 2004 Baja Owner's Manual page 108

Keys and doors
DISARM" button on the transmitter. switch to "ON".
! Tripped sensor identification
If an electronic chirp sounds four times and the turn
signal lights flash four times when you disarm the sys-
tem, this indicates that the alarm was triggered. The
number of times the indicator light flashes indicates
what sensor caused the alarm condition.
To enter identification mode:
1. Open the driver's door and leave it open.
2. Turn the ignition switch to "ON" two times. ("LOCK"
→ "ON" → "LOCK" → "ON" → "LOCK")
3. The indicator light will start flashing.
The indicator light provides the following indications.
Flashing one time: Any door has been opened.
Flashing three times: The impact sensor in the sys-
tem's unit has been activated. This may indicate that
your vehicle has been shocked or tampered with by
some outside force and/or unauthorized person.
Flashing four times: The ignition switch has been
turned on or the battery has been disconnected.
NOTE
The battery must be reconnected before the indi-
cator light will flash.
To exit this mode, close the door and turn the ignition
– CONTINUED –
2-21