Summary of Contents for Campania International FT-125 X3
Page 1
FT-125 X3 Fountain Assembly Instructions Fountain Information: • Two people are recommended for the installation of this fountain! • This fountain holds approximately 5 gallons of water. • This fountain uses a medium fountain cover: FTNCOV-MED • Compatible with #10 Refill Device and LED kits •...
Page 2
FT-125 X3 Fountain Assembly Instructions Two people are recommended for the installation of this fountain! Fountain Set-Up: Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is installed properly, please read our instructions and tips before you begin.
Page 3
FT-125 X3 Fountain Assembly Instructions Step 7 - Attach the loose end of the tubing to the CPVC pipe protruding inside the basin. Step 8 - Take the second piece of tubing and attach each end to the CPVC pipes protruding at the back of the basin (FT-125B) and the top of the cut out in the back of the feature (FT-125A).
Page 4
Maintenance: Pump Care - The fountain relies heavily on the quality of the pump. A well-maintained pump can last several years. Step 1 - Fully submerge: Ensure the pump is fully submerged at all times to avoid damage. Step 2 - E nsure water level is sufficient: Check water levels regularly as water may evaporate over time, and periodically change water to avoid algae buildup.