Table of Contents
Advertisement
Boilovers, melts, and
hot sugary spills on
the glass
6.
Hints and Tips
Problem
The cooktop
No power.
cannot
Be turned on.
The glass is being
Rough-edged cookware.
scratched.
Unsuitable, abrasive scourer or
cleaning products being used.
hob warning indicator
The thermocouple within the hob is
is flashing
failure
8.
Installation
8.1
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant work surface
material to avoid larger deformation caused by the heat radiation from the hotplate. As shown below:
X
Remove these immediately with a
fish slice, palette knife or razor
blade scraper suitable for Ceramic
glass cooktops, but beware of hot
cooking zone surfaces:
1. Switch the power to the cooktop
off at the wall.
2. Hold the blade or utensil at a 30°
angle and scrape the soiling or
spill to a cool area of the cooktop.
3. Clean the soiling or spill up with
a dish cloth or paper towel.
4. Follow steps 2 to 4 for 'Everyday
soiling on glass' above.
Possible causes
L
H
D
B
X
• Remove stains left by melts and
sugary food or spillovers as soon
as possible. If left to cool on the
glass, they may be difficult to
remove or even permanently
damage the glass surface.
• Cut hazard: when the safety cover
is retracted, the blade in a scraper
is razor-sharp. Use with extreme
care and always store safely and
out of reach of children.
Make sure the ceramic hob is connected to the
power supply and that it is switched on.
Check whether there is a power outage in your
home or area. If you've checked everything and
the problem persists, call a qualified technician.
Use cookware with flat and smooth bases. See
'Choosing the right cookware'.
See 'Care and cleaning'.
Please call a qualified technician.
W
A
X
11
What to do
X
Advertisement
Table of Contents
