Setting Up The Projector For A Wired Lan Connection [Wired Lan] - NEC UM383WL User Manual

Setting up the Projector for a Wired LAN Connection [WIRED LAN]

Important
• Consult with your network administrator about these settings.
• When using a wired LAN connection, connect a LAN cable (Ethernet cable) to the LAN port (RJ-45) of the
projector. (→ page 92)
TIP: The network settings you make will not be affected even when [RESET] is done from the menu.
[WIRED LAN]
[SETTINGS]
[RECONNECT]
[DISABLE]
[ENABLE]
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[GATEWAY]
[AUTO DNS]
Retry to connect the projector to a network.
Wired LAN connection will be turned off.
Wired LAN connection will be turned on.
ON ��������������������������� IP address, subnet mask, and gateway will be
automatically assigned to the projector from
your DHCP server�
OFF�������������������������� Specify IP address, subnet mask, and gateway
assigned by your network administrator�
Set your IP address of the network connected to the
projector.
Set your subnet mask number of the network connected
to the projector.
Set the default gateway of the network connected to the
projector.
ON ��������������������������� DHCP server will automatically assign IP address
of DNS server connected to the projector�
OFF�������������������������� Set your IP address of DNS server connected
to the projector�
76
5. Using On-Screen Menu