Mitsubishi Electric PUHZ-RP200YKAR1 Service Manual page 121

PUHZ-RP60VHA4
OPERATING PROCEDURE
1. Removing the service panel and top panel
(1) Remove 3 service panel fixing screws (5 × 10) and slide
the hook on the right downward to remove the service
panel.
(2) Remove screws (3 for front, 3 for rear/5 × 10) of the top
panel and remove it.
2. Removing the fan motor (MF1)
(1) Remove the service panel. (See Photo 1)
(2) Remove the top panel. (See Photo 1)
(3) Remove 5 fan grille fixing screws (5 × 10) to detach the
fan grille. (See Photo 1)
(4) Remove a nut (for right handed screw of M6) to detach
the propeller. (See Photo 2)
(5) Disconnect the connector CNF1 on controller circuit
board in electrical parts box.
(6) Remove 4 fan motor fixing screws (5 × 25) to detach the
fan motor. (See Photo 3)
3. Removing the electrical parts box
(1) Remove the service panel. (See Photo 1)
(2) Remove the top panel. (See Photo 1)
(3) Disconnect the indoor/outdoor connecting wire from
terminal block.
(4) Remove all the following connectors from controller circuit board;
fan motor, LEV, thermistor<Outdoor pipe>, thermistor<Shell>,
thermistor<Discharge>, thermistor<Outdoor 2-phase pipe>,
thermistor<Outdoor>, thermistor<Heatsink>,
high pressure switch, 4-way valve and bypass valve.
Then remove a screw (4 × 8) from the valve bed to
remove the lead wire.
Pull out the disconnected wire from the electrical parts box.
<Diagram symbol in the connector housing>
• Fan motor (CNF1)
• LEV (LEV-A and LEV-B)
• Thermistor <Outdoor pipe> (TH3) (TH33)
• Thermistor <Discharge> (TH4)
• Thermistor <Outdoor 2-phase pipe, Outdoor> (TH7/6)
• Thermistor <Heatsink> (CN3)
• High pressure switch (63H)
• 4-way valve coil (21S4)
• Bypass valve coil (SV2)
• Thermistor <Shell> (TH32)
(5) Remove the terminal cover and disconnect the compressor
lead wire.
(6) Remove an electrical parts box fixing screw (4 × 10) and
detach the electrical parts box by pulling it upward.
The electrical parts box is fixed with 2 hooks on the left
and 1 hook on the right.
PUHZ-RP71VHA4
PHOTOS & ILLUSTRATION
Photo 1
Fan grille
Grille fixing screws
Photo 2
Propeller
Nut
Front panel fixing screws
Photo 4
Terminal block
(TB1)
121
Top panel fixing screws
Slide
Service panel
fixing screws
Photo 3
Front panel
Fan motor fixing screws
Electrical parts box
Controller circuit
board (C.B.)
Top panel
Service panel
Fan
motor
(MF1)
Fan motor
fixing screws
Electrical parts
box fixing screw