Require Output Sequence
When an output sequence is Required, all output data must conform to an edited sequence or the scanner will not transmit
the output data to the host device. When it's On/Not Required, the scanner will attempt to get the output data to conform
to an edited sequence but, if it cannot, the scanner transmits all output data to the host device as is.
When the output sequence is Off, the bar code data is output to the host as the scanner decodes it. Default = Off.
Note: This selection is unavailable when the Multiple Symbols Selection is turned on.
Required
*Off
Multiple Symbols
When this programming selection is turned On, it allows you to read multiple symbols with a single push of the scanner's button.
If you push and hold the button, aiming the scanner at a series of symbols, it reads unique symbols once, beeping (if turned on)
for each read. The scanner attempts to find and decode new symbols as long as the button is pushed. When this programming
selection is turned Off, the scanner will only read the symbol closest to the aiming beam. Default = Off.
On
No Read
With No Read turned On, the scanner notifies you if a code cannot be read. If using an EZConfig Tool Scan Data Window (see
page 10-3), an "NR" appears when a code cannot be read. If No Read is turned Off, the "NR" will not appear. Default = Off.
On
* Discard Partial Sequence
On/Not Required
* Off
3 - 19