Connecting With Rs232 Serial Port - Honeywell Vuquest 3330g User Manual

2. Connect the appropriate interface cable to the device and to the terminal/computer.
3. Turn the terminal/computer power back on. The scanner beeps.
4. Verify the scanner operation by scanning a bar code from the
beeps once.
The unit defaults to an IBM PC AT and compatibles keyboard wedge interface with a USA keyboard. A carriage return (CR)
suffix is added to bar code data.

Connecting with RS232 Serial Port

1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to the scanner.
Note: For the scanner to work properly, you must have the correct cable for your type of terminal/computer.
3. Plug the serial connector into the serial port on your computer. Tighten the two screws to secure the connector to the
port.
4. Once the scanner has been fully connected, power up the computer.
This interface programs 115,200 baud, 8 data bits, no parity, and 1 stop bit.
Note: Please note, the end of the cable with the ferrite plugs into the scanner. The end of the cable with the label "DO NOT
connect this end to the bar code scanner" plugs into the computer.
1 - 2
Scanner
Keyboard Wedge
Connection:
Scanner RS232
Serial Port
Connection:
Sample Symbols in the back of this manual. The scanner