Pontiac 1998 Grand Am Owner's Manual page 150

PREV (1): Press PREV or the SEEK down arrow to
search for the previous selection. A minimum
three-second blank gap is needed for the player to stop
at the beginning of the selection. The tape direction
arrow will blink during the SEEK operation and the
m u d will mute in this mode.
NEXT (2):
Press
NEXT
or the SEEK up arrow to
search for the next selection. The tape direction arrow
will blink during the SEEK operation and the sound will
mute in this mode.
(4): Press
this button to reduce background tape noise
(noise reduction is only available in the cassette mode).
The double-D symbol will appear on the display.
REV (5): Press this button to rapidly reverse the tape.
The tape will rapidly reverse to the beginning of the
cassette
reel
or
until you press REV again. Use the
SEEK button or the TUNE knob to play the radio during
REV. The radio plays the last selected station.
FWD (6): Press this button to rapidly advance the tape.
The tape will rapidly advance to the end of the cassette
reel or until you press
FWD
again. Use the SEEK button
or the TUNE knob
to play
the radio during F W D . The
radio plays the last selected station.
PROG:
Press this button on the remote cassette player
to go from one side of the tape to the other.
CD/PLAY: After
a
cassette tape and a CD have been
inserted, press the CDPLAY button to switch between
the CD player and the cassette tape player. Both features
cannot be played at the same time.
EJECT:
Press this button on the remote cassette player
to remove the tape.
EJECT
can be used with either the
ignition or radio off. Also, you must press EJECT before
loading a cassette
with
the radio off to allow loading.
CLN: If this
message appears on the display, the
cassette tape player needs to be cleaned. It will still play
tapes, but you should
clean it
as soon as possible to
prevent damage to the tapes and player. See "Care of
Your
Cassette Tape Player" in the Index. After you
clean
the player, press and hold RECALL on the radio and the
EJECT button on the remote cassette at the same time
for five seconds to reset the CLN indicator. The radio
will display
---
to show the indicator was reset.
3-19