Table of Contents
Advertisement
No.
Item
16
Display of
< READY> Displayed on the remote controller
[READY]
1) When the following check codes are indicated
[HEAT READY]
2) During forced thermo. OFF
3) When the above indoor units that cannot operate stay in
4) When the indoor fan stops because the system performs
<HEAT READY> Displayed on the remote controller
When the indoor fan stops in order to prevent discharge of cool
air when heating operation started or during heating operation.
(including the defrost operation during thermo. OFF)
17
Selection of
1) Selection of the contents that can be operated by the remote controller at the indoor
central control
mode
2) Setting contents
In case of TCC-LINK central control
Operation from
TCC-LINK
central control
Individual
[Central 1]
[Central 2]
[Central 3]
[Central 4]
(
: Operation possible
Outline of specifications
Open phase of power supply wiring [P05] was detected.
There is an indoor unit that detected the indoor overflow
[P10].
There is an indoor unit that detected the interlock alarm
[L30].
[COOL/DRY] operation is unavailable because the other
indoor unit operates with [HEAT] mode.
[HEAT] operation is unavailable because COOL priority
(SW11-bit1 of the Outdoor I/F P . C. board is ON) is set and
the other indoor unit operates with [COOL/DRY] mode.
thermo. OFF status.
[Recovery operation for heating refrigerant (Oil)].
unit side is possible according to setting at the central controller side.
Operation on RBC-AMT32E
ON/OFF
Operation
setting
selection
×
×
×
×
×
×
: Operation impossible)
Timer
Temp.
Air speed
setting
setting
setting
×
×
×
×
– 27 –
FILE NO. SVM-16042
Remarks
< READY> display
No display for wireless
type remote controller
<HEAT READY>
display
On
Air direction
RBC-AMT32E
setting
[Central control]
display
Advertisement
Table of Contents
