Oldsmobile 2000 Silhouette Owner's Manual page 141

To program the new key:
1. Insert the ignition key in the ignition and start the
engine. If the engine will not start see your dealer
for service.
2. After the engine has started, turn the key to OFF,
and remove the key.
3. Insert the key to be programmed and turn it to RUN
within 10 seconds of removing the previous key.
4. The SECURITY message will turn off once the key
has been programmed. It may not be apparent that
the SECURITY message went on due to how
quickly the key is programmed.
5. Repeat Steps 1 through 4 if additional keys are to
be programmed.
If you are ever driving and the SECURITY message
comes on and stays on, you will be able to restart your
engine if you turn it off. Your PASS
however, is not working properly and must be serviced
by your dealer. Your vehicle is not protected by the
-
PASS Key III system at this time.
If you lose or damage a PASS
dealer or a locksmith who can service PASS
have a new key made.
-
Key III system,
-
Key III key, see your
-
Key III to
New Vehicle "Break
NOTICE:
Your vehicle doesn't need an elaborate
-
"break in." But it will perform better in the long
run if you follow these guidelines:
D
Don't drive at any one speed
--
slow for the first 500 miles (805 km).
-
Don't make full throttle starts.
D
Avoid making hard stops for the first
200 miles (322 km) or so. During this time
your new brake linings aren't yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking
time you get new brake linings.
D
Don't tow a trailer during break
See "Towing a Trailer" in the Index for
more information.
In"
-
--
fast or
-
in guideline every
-
in.
2-37