Roller shutter drive RolTop /D+ 868/915
Table Of Contents
1
2
General for instructions
2.1
2.2
2.3
2.4
2.5
3
3.1
3.2
4
5
5.1
5.2
5.3
5.4
5.5
5.6
6
7
8
9
10
11
12
Roller shutter drive RolTop /D+ 868
1
Operating and installation
1
instructions
1
Please keep these operating instructions for later use, to be
available throughout the life of the product!
1
The German manual is the original version.
1
All other documents represent the language translations of
the original text.
2
All rights in the case of a patent, utility model or ornamental
2
design registration are reserved.
2
General for instructions
2
2
The content structure is based on the life cycles of the elec-
tric motor drive (hereinafter referred to as "Product").
2
The manufacturer reserves the right to make changes to
the Specifi cations stated in these Operating Instructions
2
at any time. These may, in individual cases, be different
from the respective product version, however the functional
3
information will not undergo signifi cant changes or become
invalid. The current version of the Specifi cations may be
3
requested from the manufacturer at any time. No claims
4
may be asserted against the manufacturer as a result of the
preceding sentence. Deviations from text or picture state-
4
ments are possible and depend on the technical develop-
ment, features, and accessories of the products. Deviating
information on special versions will be explained by the
4
manufacturer in the sales documentation. Other information
shall remain unaffected by these provisions.
5
2.1
Standards and Directives
5
During the design process, the basic health and safety
requirements of the applicable laws, Standards and Direc-
tives were complied with. The safety is confi rmed by the
5
All safety information in these Operating Instructions refer
5
to the laws and regulations currently applicable in Germany.
All instructions in the Operating Instructions shall be ob-
served without limitation and at any time. Beside the safety
5
instructions contained in these Operating Instructions, the
provisions for accident prevention, environmental protection
5
and occupational safety, which are applicable for the op-
erating site, must be observed. Provisions and Standards
5
for the safety rating can be found in the EC Declaration of
Conformity
6
2.2
Intended use
6
The product is intended for use in façade engineering to
drive electrically powered roller shutters.
6
The determining factor for the drive is the elero drive com-
6
putation program (http://elero.com/
de;service;antriebsberechnungsprogramm.htm).
6
Further fi elds of application have to be arranged with the
manufacturer, elero GmbH Antriebstechnik (see Address).
7
The operator will be solely responsible for damages result-
7
ing from improper use of the product. The manufacturer
cannot be held liable for personal or material damages
caused by misuse or procedural errors, and by improper
operation and commissioning.
The product may be operated only by trained and author-
ized personnel under observance of all safety.
138172801_EN_0614