Mounting; Electric Power Supply; Sawdust-Bag Connection; Support Apparatus Connection - Uludag G-250 Manual For Introduction, Operation And Maintenance

3.2. Mounting

We recommend that you should mount the machine onto a bench having approximately
800 mm height and minimum 750x500 length and width. As a machine workplace, choose
a place which is well lighted and having sufficient space to accomplish cutting operations.
Machine doesn't need a special leveling adjustment, the smoothness of the bench surface
on which it is mounted will be enough.
In addition, it is also possible for the machine to be fixed by the two holes at the back of
the foot with two M10x100 bolts onto the bench.

3.3. Electric Power Supply

Before connecting the machine to the power supply line (earthed socket), check if the
voltage written on the electric motor name plate is compatible with the line voltage. If the
machine is equiped with three-phase electric motor, ensure that the rotation is in the
direction shown by the arrow on front side of sawbladeguard. If not, replace the phase
line at the centre with any of the phase line at sides.
NOTE:
• Electric motor is designed to be used as alternative. If you are not working on the
machine, we recommend to shut it down.
• If you happen to make use of extension cable, make sure that the cross-section
of the power supply wire has sufficient area to provide required current for the
motor power consumption. Using extension cable as short as possible is
recommended.
• Unplug the machine from power line before doing any operation on the machine.
• Do not leave the machine alone without monitoring when it is powered on.

3.4. Sawdust-Bag Connection

A sawdust bag -bag could be mounted to the connection place at the rear of machine.
3.5. Profile Support Connection Connection
The work support component belonging to your machine is supplied together with the
machine. The only thing you should do is to assemble the support shaft to the hole at the
side of set-square with bakalite screw. This part is especially used for mass cutting
operations.

3.6. Clamp Connection

Your machine's clamp equipment will facilitate your cutting operation on the machine.
Before starting the cutting operation, tighten and secure the work piece in the clamp on
the machine, thus, this will prevent the possibility of work piece to be thrown away.
21