Kia Optima Hybrid 2017 Owner's Manual page 544

WARNING
n Carbon monoxide
Carbon monoxide poisoning and suf‐
focation is possible if the engine is
left running in a poorly ventilated or
unventilated location (such as inside
a building).
Distributing the sealant
11. Immediately drive approximately
7~10 km (4~6 miles or, about 10
min) to evenly distribute the seal‐
ant in the tire.
CAUTION
Do not exceed a speed of 80 km/h
(50 mph). If possible, do not fall be‐
low a speed of 20 km/h (12 mph).
While driving, if you experience any
unusual vibration, ride disturbance
or noise, reduce your speed and
drive with caution until you can
safely pull off of the side of the
road. Call for road side service or
towing.
(Continued)
(Continued)
When you use the Tire Mobility Kit,
the tire pressure sensors and wheel
may be stained by sealant. There‐
fore, remove the tire pressure sen‐
sors and wheel stained by sealant
and we recommend to have it in‐
spected by an authorized Kia dealer.
Checking the tire inflation
pressure
OJFH065015
1. After driving approximately
7~10 km (4~6 miles, or about 10
minutes), stop at a suitable loca‐
tion.
2. Connect connection hose (10) of
the compressor directly to the tire
valve.
3. Connect between compressor and
the vehicle battery using the cable
and connectors.
4. Adjust the tire inflation pressure to
200 kPa (29 psi). With the ignition
switched on, proceed as follows.
- To increase the inflation pres‐
sure: Switch on the compressor,
position I. To check the current
inflation pressure setting, briefly
switch off the compressor.
WARNING
Do not let the compressor run for
more than 10 minutes, otherwise
the device will overheat and may be
damaged.
- To reduce the inflation pressure:
Press the button (9) on the com‐
pressor.
8
8-19