Mazda 2006 Tribute Owner's Manual page 42

JOBNAME: No Job Name PAGE: 42 SESS: 1 OUTPUT: Wed Jun 15 16:24:35 2005
/ford_pdm/ford/own2002/j14/mpdiff
Lights
6. Without turning, carefully pull
bulb out of headlamp assembly.
Note: The bulb's metal base gets
very hot during headlamp operation.
Be sure the bulb base is cool before
handling.
If the bulb is accidentally touched,
it should be cleaned with rubbing
alcohol before being used.
7. Insert the glass end of the new
bulb into the headlamp assembly. When the bulb's three metal tabs
are aligned with the grooves in the plastic base, push the bulb into
the lamp assembly until the bulb's metal base contacts the plastic
base.
8. Rotate the retainer spring over the bulb's metal base and secure it
on the bulb hooks.
9. Install rubber boot on the lamp assembly. Be sure to press firmly
around the perimeter of the boot and around the bulb to ensure the
proper seal of the bulb.
10. Connect the electrical connector into the rear of the bulb until it
"snaps."
Replacing front parking lamp/turn signal bulbs
For bulb replacement, see your authorized dealer.
Replacing side repeater bulbs
1. Turn the headlamp switch to
off.
2. Carefully pry the lamp assembly
away from the fender.
3. Rotate the bulb socket
counterclockwise to remove it
from the lamp assembly.
4. Pull the bulb straight out.
Reverse steps to reinstall bulb(s).
Replacing foglamp bulbs
For bulb replacement, see your authorized dealer.
42
PAGE: 42 OP: root EDIT SESSION: 1 DATE: JUNE 15 2005 at 16:24 JOB: @ibm2/ford_pdm/CLS_ford/GRP_own2002/JOB_j14/DIV_mpdiff
DIFF-MARKED Review Copy ——
(OLD=2006 Tribute fus Owners Guide (post-2002-fmt) 06.5 Tribute Champ (#26074) (May-02-2005 14:29:19))
(NEW=2006 Tribute fus Owners Guide (post-2002-fmt) 2006.5 Tribute CNE Review (#26074) (Jun-15-2005
16:18:13))
2006 Tribute (j14), Owners Guide (post-2002-fmt) (own2002), Market: USA (fus)
art=j14cf312_a
art=mntmc305_d