Lincoln 2000 Continental Owner's Manual page 90

Controls and features
Procedure to program spare SecuriLock
New SecuriLock
your vehicle.
Conventional (non-SecuriLock ) keys cannot be programmed to your
vehicle.
You will need to have two previously programmed SecuriLock
the new unprogrammed SecuriLock
procedure. Please read and understand the entire procedure before you
begin.
1. Insert the first previously programmed SecuriLock
ignition and turn the ignition from OFF to ON (maintain ignition in ON
for at least one second).
2. Turn ignition to OFF and remove the first SecuriLock
ignition.
3. Within five seconds of turning the ignition to OFF, insert the second
previously programmed SecuriLock
ignition from OFF to ON (maintain ignition in ON for at least one second
but no more than five seconds).
4. Turn the ignition to OFF and remove the second SecuriLock
from the ignition.
5. Within 10 seconds of turning the ignition to OFF, insert the
unprogrammed SecuriLock
and turn the ignition from OFF to ON (maintain ignition in ON for at
least one second). This step will program your new SecuriLock
6. To program additional SecuriLock
step 1.
If the programming procedure was successful, the new SecuriLock
key(s) will start the vehicle's engine. The theft indicator (located on the
instrument cluster) will light for three seconds and then go out.
If the programming procedure was not successful, the new SecuriLock
key(s) will not operate the vehicle's engine. The theft indicator will flash
on and off. Wait at least one minute and then repeat the procedure from
step 1. If failure repeats, bring your vehicle to your dealership to have
the spare SecuriLock
90
keys must have the correct mechanical key cut for
key (new key/valet key) into the ignition
key(s) programmed.
keys to your vehicle
key readily accessible for the
key into the ignition and turn the
key(s), repeat this procedure from
keys and
key into the
key from the
key
key.