Tire Chains; Tire Rotation Recommendations - Jeep 2006 Wrangler Owner's Manual

Hide thumbs Also See for 2006 Wrangler:
Table of Contents

Advertisement

228 STARTING AND OPERATING
Tires may also cause the vehicle to pull left or right.
Alignment will not correct this problem. See your autho-
rized dealer for proper diagnosis.
Improper alignment will not cause vehicle vibration.
Vibration may be a result of tire and wheel out-of-
balance. Proper balancing will reduce vibration and
avoid tire cupping and spotty wear.

TIRE CHAINS

Install chains on rear tires only. Tire chains may be
installed on all models except the Sahara and Rubicon.
Follow these recommendations to guard against damage
and excessive tire and chain wear:
• Use chains on P215/75R15 tires only. P225/75R15,
LT30 x 9.50R15, and LT245/75R16 tires do not provide
adequate clearance.
• Use SAE class "S" tire chains or traction devices only.
• Chains must be the proper size for the vehicle, as
recommended by the chain manufacturer.
• Follow tire chain manufacturer's instructions for
mounting chains.
• Install chains snugly and tighten after.6 mile (1 km) of
driving.
• Do not exceed 30 mph (48 km/h).
• Drive cautiously, avoiding large bumps, potholes and
extreme driving maneuvers.

TIRE ROTATION RECOMMENDATIONS

Tires on the front and rear axles of vehicles operate at
different loads and perform different steering, handling,
and braking functions. For these reasons, they wear at
unequal rates, and develop irregular wear patterns.

Advertisement

Table of Contents
loading

Table of Contents