Specific Safety For Drill/Mill - Hafco Woodmaster BP-430A Operation Manual

2.2 SAFE WORK PROCEDURE FOR BAND SAWS
DO NOT use this machine unless you have been instructed in its safe use and
Safety glasses must
be worn at all times
in work areas
Sturdy footwear must
be worn at all times in
work areas
PRE-OPERATIONAL SAFETY CHECKS
1. Ensure no slip/trip hazards are present in workspaces and walkways.
2. Locate and ensure you are familiar with the operation of the ON/OFF starter and E-Stop.
3. Check that all guards are in position.
4. Ensure push stick is available.
5. Lower the blade guide and guard to full effect.
6. Start the dust extraction unit before using the saw.
7. Faulty equipment must not be used. Immediately report suspect machinery.
OPERATIONAL SAFETY CHECKS
NOTE : Keep your fingers off the line of the cut at all times.
1. Never leave the machine running unattended.
2. The work piece should be fed forward evenly and held firmly on the table to ensure effective
control during cutting whilst keeping hands in a safe position.
3. Use a push stick when feeding material past the blade.
4. Do not force a wide blade on a cut of small radius. Use relief cuts when cutting sharp curves.
5. Before making adjustments switch off the saw and bring the machine to a complete stand
still.
6. Stop the machine before attempting to back the work away from the blade.
7. Stop the saw immediately if the blade develops a 'click' . Report it to your supervisor
AFTER OPERATION
1. Switch off the saw and reset all guards to a fully closed position.
2. Leave the machine in a safe, clean and tidy state.
DO NOT
 Attempt to cut very small item
 Cut cylindrical or irregular stock
 Leave the machine running unattended
OPERATION MANUAL
operation and have read and understood this manual
Long and loose hair
must be contained.
Close fitting
protective clothing
must be worn
9
Gloves must not be
worn when using this
machine.
Rings and jewelery
must not be worn.