Hyundai 2005 Santa Fe Owner's Manual page 75

1
FEATURES OF YOUR HYUNDAI
64
Correcting Azimuth Indicator
It is needed to correct the error between a
current azimuth to terrestrial magnetism sen-
sor and the displayed azimuth in the vehicle
position.
How to correct azimuth indicator
1. If you push and hold the "M (MODE)" switch
for less than 4.5 seconds, the azimuth indi-
cator will start blinking with the vehicle's
present direction.
2. Slowly rotate the vehicle one turn(360 de-
gree) within 128 seconds.
The rotation could be made at any
direction(left or right) in an open space.
3. When the rotation is finished, the azimuth
compass indicator will stop blinking and the
error correction is completed.
If the indicator continues to blink, rotate the
vehicle a bit more until the blinking stops.
The compass heading will appear after 3
seconds when the correcting error is com-
pleted.
NOTE:
Rotate the vehicle one turn (90 degree) as
shown in the drawing if the vehicle has no
HSM2185
place to rotate.
The azimuth compass indicator correc-
tion will be cancelled:
1. If you press "M (MODE)" switch for more
than 0.5 second.
2. When the vehicle is not rotated within 128
seconds after the blinking of the indicator.
NOTE:
The azimuth may display abnormally in
specific places (tunnel, parking lot in build-
ing, underground parking lot, near trans-
former substation, etc.). It is normal and the
azimuth is displayed normally when escap-
ing above mentioned places.
How to correct terrestrial deviation.
1. Press "M (MODE)" switch for more than 4.5
seconds, then the present terrestrial devia-
tion angle value will be displayed.
2. Press " (UP)" or "
HSM2186
less than 0.5 second to correct the terrestrial
deviation angle within 30 seconds.
(DOWN)" switch for