Hyundai 2004 Santa Fe Owner's Manual page 102

B970C01O-GAT
Automatic Operation
The FATC (Full Automatic Temperature Con-
trol) system automatically controls the heating
and cooling by doing as follows:
1. Push the "AUTO" switch. The indicator light
will come on confirming that the Face, Floor
and/or Bi-Level modes as well as the blower
speed and, the air conditioning will operate if
ambient temperature is higher than 32°F
(0°C) and automatically turns off if the ambi-
ent temperature drops below 32°F(0°C).
2. Push the "TEMP" button to set the desired
B970C01O
temperature.
The temperature will increase to the maxi-
mum "HI" by pushing on the
push of the button will cause the temperature
to increase by 1°F(0.5°C).
The temperature will decrease to the mini-
mum "LO" by pushing on the
push of the button will cause the temperature
to decrease by 1°F(0.5°C).
NOTE:
If the battery has been discharged or dis-
connected, the temperature mode will reset
to Fahrenheit degree.
This is a normal condition and you can
adjust the temperature mode from Fahren-
heit to Centigrade as follows;
Press the TEMP down (
or more with the AMB button held down.
The display shows that the unit of tempera-
ture is adjusted to Fahrenheit or Centigrade
(°F °C or °C
B970C03O
button. Each
Photo sensor
button. Each
NOTE:
Never place things on the sensor which is
located in the car on the instrument panel
to ensure better control of the heating and
cooling system.
1
FEATURES OF YOUR HYUNDAI
89
) button 3 seconds
°F).
HSM502