Honda 2010 CR-V Owner's Manual page 169

09/07/16 18:12:45 31SWA630_168
SCAN The scan function gives
−
you a sampling of all channels while
in the channel mode. In the category
mode, only the channels within that
category are scanned. To activate
scan, press the SCAN button. The
system plays each channel in
numerical order for a few seconds,
then selects the next channel. When
you hear a channel you want to
continue listening to, press the
button again.
Preset − You can store up to 12
preset channels using the six preset
buttons. Each button stores one
channel from the XM1 band and one
channel from the XM2 band.
To store a channel:
1. Press the XM button. Either XM1
or XM2 will show in the display.
Playing the XM Radio (EX-L model without navigation system)
2. Use the tune, seek, or scan
function to tune to a desired
channel.
In category mode, only channels
within that category can be selected.
In channel mode, all channels can be
selected.
3. Pick the preset button you want
for that channel. Press and hold
the button until you hear a beep.
4. Repeat steps 2 and 3 to store the
first six channels.
5. Press the XM button again. Store
the next six channels using steps 2
and 3.
Once a channel is stored, press and
release the proper preset button to
tune to it.
XM Radio Display Messages
''LOADING'' XM is loading the
−
audio or program information.
The channel
''OFF AIR'' −
currently selected is no longer
broadcasting.
The encryption
''UPDATING'' −
code is being updated. Wait until the
encryption code is fully updated.
Channels 0 and 1 should still work
normally.
''NO SIGNAL'' − The signal is
currently too weak. Move the vehicle
to an area away from tall buildings,
and with an unobstructed view of the
southern horizon.
CONTINUED
163