Compressor Assembly; Storage And Transport; Setting Up - BOCK HGX34e A Series Assembly Instructions Manual

4 | Compressor assembly

4.1 Storage and transport

?
Fig. 5
Fig. 6

4.2 Setting up

D
GB
3
F
E
Fig. 7
Fig. 8
Fig. 9
10
INFO New compressors are factory-filled with inert gas. Leave this ser-
vice charge in the compressor for as long as possible and prevent
the ingress of air. Check the compressor for transport damage
before starting any work.
Storage at (-30°C) - (+70°C), maximum permissible relative humidity
10% - 95%, no condensation
Do not store in a corrosive, dusty, vaporous atmosphere or in a com-
bustible environment.
Use transport eyelet.
Do not lift manually!
Use lifting gear!
ATTENTION! Attachments (e.g. pipe holders, additional units, fastening parts,
etc.) directly to the compressor are not permissible!
2
Provide adequate clearance for maintenance work.
Ensure adequate compressor ventilation.
Do not use in a dusty, damp atmosphere or a combustible
environment.
Set up on an even surface or frame with sufficient load-
bearing capacity.
1
F
E
D
C